Year · Make · Model
What the National Highway Traffic Safety Administration knows about this vehicle: every recall, every consumer complaint, every defect investigation, every NCAP crash test. Sourced directly from NHTSA data feeds.
THE SAFETY BELT ANCHORAGE BOLTS DO NOT COMPLY WITH THE REQUIREMENTS OF FMVSS 210, "SEAT BELT ASSEMBLY ANCHORAGES". THE SEAT ANCHORAGES COULD NOT MAINTAIN LOAD OF 5,000 LBS FOR 10 SECONDS.
RiskTHE SAFETY BELTS MIGHT NOT ADEQUATELY PROTECT SEATOCCUPANTS IN THE EVENT OF A SUDDEN STOP OR ACCIDENT.
FixREPLACE THE ANCHORAGE BOLTS WITH BOLTS OF A LARGER DIAMETER, WHICH MEET THE LOAD REQUIREMENTS OF FMVSS 210.
INCORRECT SCREWS WERE USED TO ATTACH THE PLYWOOD SEAT BACK TO THE SEAT FRAME.
RiskTHE DRIVER'S SEAT BACK DOES NOT MEET THE STRENGTHREQUIREMENTS OF FMVSS 207, "SEATING SYSTEM". SHOULD THE SEAT BACK FAIL WHILETHE BUS IS IN MOTION, THE OPERATOR COULD LOSE CONTROL OF THE BUS.
FixREMOVE INCORRECT SCREWS ATTACHING THE PLYWOOD BACK TO THE SEAT FRAME AND INSTALL PROPER SCREWS.
THE DRIVESHAFT USED WITH SOME ENGINE/TRANSMISSION COMBINATIONS HAD INSUFFICIENT WELDS JOINING SOME OF THE COMPONENTS.
RiskTHE BAD WELDS CAN DEVELOP CRACKS THAT CAN CAUSE COMPLETESEPARATION OF THE DRIVESHAFT. THIS CAN RESULT IN LOSS OF MOTIVE POWER FOR THEVEHICLE AND POSSIBLE LOSS OF VEHICLE CONTROL.
FixREPLACE DEFECTIVE NORTH AMERICAN DRIVESHAFTS WITH SPICER DRIVESHAFTS.
THE CENTER ACTUATOR THAT RELEASES TWO CATCHES VIA TWO PULL RODS CAN BECOME NON-FUNCTIONAL FROM POOR OR IMPROPER MAINTENANCE, LACK OF LUBRICATION, CORROSION, OR A COMBINATION ALL THREE CAUSES.
RiskWHEN THE CENTER ACTUATOR IS NON-FUNCTIONAL, THE WINDOWIS VERY DIFFICULT TO OPEN, AND WOULD NOT FUNCTION AS AN EMERGENCY EXIT IN CASEOF A VEHICULAR ACCIDENT.
FixREMOVE THE OLD CENTER ACTUATOR AND INSTALL AN IMPROVED ACTUATOR.
THE FUEL SHUT-OFF SOLENOID IN THE CUMMINS 6C ENGINE MAY BE FAULTY, CAUSING SPONTANEOUS INTERRUPTION OF FUEL FLOW TO THE ENGINE DURING NORMAL OPERATION. THIS RESULTS IN LOSS OF POWER TO DRIVING WHEELS, POWER STEERING, AND OTHER POWER ASSISTED OPERATING SYSTEMS.
RiskLOSS OF ENGINE POWER AND SECONDARY LOSS OF POWER ASSISTEDSYSTEMS REDUCES STEERING CONTROL, BRAKING ABILITY, VISUAL SYSTEMS AND OTHERPOWER ASSISTED OPERATING SYSTEMS, RESULTING IN INCREASED RISK OF VEHICLEACCIDENT.
FixWHERE NECESSARY, REPLACE THE SOLENOID SPRING, ADJUST SOLENOID, REPLACE WIRES, AND VERIFY MAXIMUM POWER REQUIREMENTS TO THE SOLENOID.
THE STEERING LINKAGE (DRAG LINK) BETWEEN THE STEERING GEAR PITMAN ARM AND THE STEERING ARM ON THE AXLE MAY HAVE BEEN IMPROPERLY FASTENED.
RiskTHE DRAG LINK COULD BECOME DISCONNECTED AT EITHER ENDWHICH RESULTS IN LOSS OF STEERING CONTROL AND THE POTENTIAL FOR AN ACCIDENT.
FixINSTALL CORRECT PINS AND PROPERLY TIGHTEN THE CASTELLATED NUTS.