Year · Make · Model
What the National Highway Traffic Safety Administration knows about this vehicle: every recall, every consumer complaint, every defect investigation, every NCAP crash test. Sourced directly from NHTSA data feeds.
THE DRIVESHAFT USED WITH SOME ENGINE/TRANSMISSION COMBINATIONS HAD INSUFFICIENT WELDS JOINING SOME OF THE COMPONENTS.
RiskTHE BAD WELDS CAN DEVELOP CRACKS THAT CAN CAUSE COMPLETESEPARATION OF THE DRIVESHAFT. THIS CAN RESULT IN LOSS OF MOTIVE POWER FOR THEVEHICLE AND POSSIBLE LOSS OF VEHICLE CONTROL.
FixREPLACE DEFECTIVE NORTH AMERICAN DRIVESHAFTS WITH SPICER DRIVESHAFTS.
THE CENTER ACTUATOR THAT RELEASES TWO CATCHES VIA TWO PULL RODS CAN BECOME NON-FUNCTIONAL FROM POOR OR IMPROPER MAINTENANCE, LACK OF LUBRICATION, CORROSION, OR A COMBINATION ALL THREE CAUSES.
RiskWHEN THE CENTER ACTUATOR IS NON-FUNCTIONAL, THE WINDOWIS VERY DIFFICULT TO OPEN, AND WOULD NOT FUNCTION AS AN EMERGENCY EXIT IN CASEOF A VEHICULAR ACCIDENT.
FixREMOVE THE OLD CENTER ACTUATOR AND INSTALL AN IMPROVED ACTUATOR.
RELEASE HANDLE FOR REAR PUSH OUT WINDOW IS NOT LOCATED IN AREA REQUIRED BY S5.2.3.1(B) OF FMVSS 217.
RiskBUSES WOULD NOT COMPLY WITH STANDARDS; IN AN EMERGENCY,EXIT FROM THE PUSH-OUT WINDOW COULD BE HAMPERED.
FixINSTALL NEW INTERIOR HANDLE ASSEMBLY TO MEET SPECIFICATIONS.
THE FUEL SHUT-OFF SOLENOID IN THE CUMMINS 6C ENGINE MAY BE FAULTY, CAUSING SPONTANEOUS INTERRUPTION OF FUEL FLOW TO THE ENGINE DURING NORMAL OPERATION. THIS RESULTS IN LOSS OF POWER TO DRIVING WHEELS, POWER STEERING, AND OTHER POWER ASSISTED OPERATING SYSTEMS.
RiskLOSS OF ENGINE POWER AND SECONDARY LOSS OF POWER ASSISTEDSYSTEMS REDUCES STEERING CONTROL, BRAKING ABILITY, VISUAL SYSTEMS AND OTHERPOWER ASSISTED OPERATING SYSTEMS, RESULTING IN INCREASED RISK OF VEHICLEACCIDENT.
FixWHERE NECESSARY, REPLACE THE SOLENOID SPRING, ADJUST SOLENOID, REPLACE WIRES, AND VERIFY MAXIMUM POWER REQUIREMENTS TO THE SOLENOID.
UPPER ANCHORAGE OF TYPE 2 SAFETY BELT INSTALLED AT THE DRIVER'S SEATING POSITION IS NOT WITHIN THE SPECIFIED RANGE AS REQUIRED BY FMVSS 210.
RiskBELTS MAY BE UNCOMFORTABLE AND OBSTRUCT VISION TO THE LEFT; BUSES WOULD NOT COMPLY WITH STANDARD.
FixINSTALL REINFORCING CHANNEL ASSURING THAT BELTS ARE WITHIN SPECIFIED RANGE.
THE ADJUSTABLE SEAT BACK STRUCTURE AND TILT MECHANISM MAY NOT WITHSTAND REARWARD FORCE REQUIRED BY FMVSS 207.
RiskBUSES ARE NOT IN COMPLIANCE WITH FMVSS 207; SEATBACKCOULD FAIL IN AN ACCIDENT INCREASING POTENTIAL FOR INJURY TO OCCUPANT.
FixINSTALL NEW SEAT BACK STRUCTURE AND TILT MECHANISM ASSEMBLY THAT COMPLIES WITH STANDARD.