1996 Spartan Gladiator

VEHICLE DESCRIPTION: FIRE TRUCKS. THESE FIRE TRUCKS ARE ALL 4-DOOR MODELS WHICH CONTAIN DUAL, FORWARD FACING PASSENGER SEATS. THE HARDWARE UTILIZED TO MOUNT THE SEAT BOX TO THE CAB FLOOR AND TO THE BACKWALL STRUCTURE, AND ALSO TO MOUNT THE TYPE 1 SEAT BELT SYSTEMS, WAS INADEQUATE TO MEET THE REQUIREMENTS OF FMVSS NOS. 207/210, ""SEATING SYSTEMS" AND "SEAT BELT ASSEMBLY ANCHORAGES."

RiskTHE SEAT BOX MOUNTING/RESTRAINING HARDWARE CAN LOOSEN OR FAIL ALLOWING THE SEAT/SEAT BOX ASSEMBLY TO BREAK FREE OF ITS MOUNTING TO THE CAB FLOOR AND/OR BACKWALL WHICH COULD CAUSE INJURY TO THE OCCUPANTS OF THOSE SEATS.

FixDEALERS WILL REPLACE THE SEAT BOX MOUNTING FASTENERS.

VEHICLE DESCRIPTION: FIRE TRUCKS. THE CAB TILT SYSTEM CONTAINS A 12 VOLT ELECTRICAL SOLENOID ASSEMBLY AS AN ACCESSORY TO THE CAB TILT ELECTRIC MOTOR/HYDRAULIC PUMP ASSEMBLY. RAIN, SNOW, SALT SPRAY OR OTHER CORROSIVE ENVIRONMENT CAN CORRODE THE SOLENOID OR "BRIDGE" THE ENERGIZING COIL WIRE TERMINAL CAUSING THE CAB TILT SYSTEM TO OPERATE UNCONTROLLABLY.

RiskTHIS COULD CAUSE THE CAB TILT SYSTEM TO ACTUATE WITHOUT CONTROL, INCREASING THE RISK OF PERSONAL INJURY.

FixDEALERS WILL INSTALL A HERMETICALLY SEALED SOLENOID ASSEMBLY.

VEHICLE DESCRIPTION: FIRE TRUCKS. IF THE DRIVER ACCELERATES IN A TURN ABOVE 20 MPH FORWARD SPEED, THE LOCK PIN IS ACTUATED AND CAUSES THE AXLE TO RESIST RETURNING TO THE STRAIGHT AHEAD POSITION AFTER THE TURN IS COMPLETED BECAUSE THE LOCK PIN IS BINDING ON THE CLAMP PLATE SURFACE.

RiskENGAGING THE LOCK PIN IN THE LCMP PLATE HOLE AT HIGH FORWARD SPEEDS CAUSES EXCESSIVE WEAR IN THE LOCK PIN AND/OR THE CLAMP PLATE HOLE. LANE CHANGES AND OTHER VEHICLE MANEUVERS WILL GREATLY INCREASE CONTACT FREQUENCY AND CAUSES WEAR, INCREASING THE RISK OF LOSS OF VEHICLE CONTROL.

FixDEALERS WILL REPLACE THE TAG AXLES ON THESE FIRE TRUCKS.

VEHICLE DESCRIPTION: FIRE TRUCKS WITH OCCUPANT SIDE ENTRY DOORS. A DIFFICULTY IN LATCHING THE SIDE ENTRY DOORS TO THE FULL CLOSED POSITION, AND/OR, THE DOORS MAY RELEASE TO THE SECONDARY LATCH POSITION. ALSO LOOSE RIVETS CAN CAUSE THE LATCH CONTROL MECHANISM TO BIND NOT ALLOWING THE DOOR TO LATCH PROPERLY WHEN SHUT.

RiskTHE CAB DOOR COULD UNLATCH FROM ITS PRIMARY LATCH WHILE THE VEHICLE IS IN MOTION, ALLOWING THE DOOR TO OPEN UNASSISTED TO THE SECONDARY LATCH POSITION.

FixDEALERS WILL REMOVE AND REPLACE THE LATCH AND ACTUATOR ON THE DOORS.