Year · Make · Model
What the National Highway Traffic Safety Administration knows about this vehicle: every recall, every consumer complaint, every defect investigation, every NCAP crash test. Sourced directly from NHTSA data feeds.
THE VEHICLES WERE ASSEMBLED WITH AN INCORRECT SUSPENSION UPPER SPRING SEAT AT THE RIGHT-REAR POSITION. IF THE VEHICLE IS INVOLVED IN A REAR IMPACT ACCIDENT, THE RIGHT-HAND REAR WHEEL HOUSE FLANGE COULD SEVER THE FUEL TANK FILLER PIPE AND SPILL FUEL.
RiskTHESE VEHICLES ARE NOT IN COMPLIANCE WITH FMVSS 301,FUEL SYSTEM INTEGRITY. SPILLED FUEL IN A LOW SPEED ACCIDENT CAN RESULT IN AFIRE.
FixINSPECT AND REPLACE INCORRECT UPPER SPRING SEAT WITH THE CORRECT PART.
THE BOLTS AND NUTS WHICH ATTACH THE BEARING-HUB ASSEMBLY TO THE REAR AXLE FLANGE ARE NOT SUFFICIENTLY TIGHTENED ON SOME VEHICLES.
RiskTHIS WOULD ALLOW EXCESSIVE MOVEMENT OF THE BEARING-HUBASSEMBLY RELATIVE TO THE REAR AXLE FLANGE AND COULD CAUSE ELONGATION ANDEVENTUAL SEPARATION OF THE ATTACHING BOLTS FROM THE REAR AXLE FLANGE. IF THISWERE TO OCCUR WHILE THE VEHICLE WAS IN MOTION, THE AFFECTED TIRE AND WHEEL COULDTRACK ERRATICALLY, EVENTUALLY CAUSING FAILURE OF THE OTHER ATTACHING BOLTS. THETIRE AND WHEEL ASSEMBLY COULD SEPARATE FROM THE VEHICLE WHICH COULD RESULT IN AVEHICLE ACCIDENT.
FixTIGHTEN REAR AXLE BEARING-HUB ASSEMBLY FASTENERS, AND REPLACE ALL THE FASTENERS ON A WHEEL IF TWO OR MORE BOLTS ARE FOUND TO BE LOOSE.
THE PASSENGER'S SIDE EASY-ENTRY SEAT ADJUSTER MAY FAIL FULLY LOCK INTO POSITION AFTER THE SEAT BACK HAS BEEN TILTED FORWARD AND THE SEAT SLID FORWARD, THEN RETURNED TO ITS ORIGINAL POSTITION.
RiskIF THE SEAT ADJUSTER FAILS TO LOCK INTO POSITION, THEPASSENGER SEAT WOULD SLIDE FORWARD IN THE EVENT OF A SUDDEN STOP OR ACCIDENT.OCCUPANTS OF THE PASSENGER SEAT WOULD FACE INCREASED RISK OF SERIOUS INJURY.
FixREPLACE THE ADJUSTER ASSEMBLY ON THE SEAT.