Year · Make · Model

2010 Medtec Type II (VAN)

What the National Highway Traffic Safety Administration knows about this vehicle: every recall, every consumer complaint, every defect investigation, every NCAP crash test. Sourced directly from NHTSA data feeds.

Open recalls

NHTSA complaints

Defect investigations

Service bulletins

Recalls

2 campaigns

11V098000·SEATS2011-02-14

MEDTEC IS RECALLING CERTAIN MODEL YEAR 2010 AMBULANCE TYPE II VANS FOR NOT COMPLYING WITH FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 207, "SEATING SYSTEMS," AND FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 210, "SEAT BELT ASSEMBLY ANCHORAGES." THE REAR FACING AMBULANCE ATTENDANT SEAT UTILIZES A STEEL FLOOR REINFORCEMENT PLATE ON THE BOTTOM SIDE OF THE ALUMINUM FLOOR SUBSTRUCTURE AND THE REINFORCEMENT PLATE WAS OMITTED IN SOME AMBULANCE BODIES.

RiskIN THE EVENT OF A CRASH, THE SEAT BELT ASSEMBLY ANCHORAGE MAY DISCONNECT FROM THE FLOOR CAUSING THE ASSEMBLY TO FAIL TO RESTRAIN THE SEAT OCCUPANT INCREASING THE RISK OF INJURY TO THAT OCCUPANT.

FixDEALERS WILL INSTALL THE MISSING REINFORCEMENT PLATE UNDER THE FLOOR SUBSTRUCTURE FREE OF CHARGE. THE RECALL IS EXPECTED TO BEGIN DURING MARCH 2011. OWNERS MAY CONTACT MEDTEC TOLL-FREE AT 1-866-263-3832.

10V511000·SEAT BELTS2010-10-19

MEDTEC IS RECALLING CERTAIN MODEL YEAR 2007 THROUGH 2010 AMBULANCES MANUFACTURED FROM SEPTEMBER 14, 2007, THROUGH APRIL 15, 2010. THE REAR FACING AMBULANCE ATTENDANT SEAT WAS NOT EQUIPPED WITH A TYPE 2 SEAT BELT ASSEMBLY, AND SO THE VEHICLES FAIL TO COMFORM TO THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 208, "OCCUPANT CRASH PROTECTION."

RiskUSE OF AN IMPROPER SEAT BELT ASSEMBLY MAY INCREASE THE RISK OF INJURY TO THE SEAT OCCUPANT IN THE EVENT OF A CRASH.

FixMEDTEC WILL NOTIFY OWNERS AND DEALERS WILL INSTALL A TYPE 2 SEAT BELT ASSEMBLY FREE OF CHARGE. THE SAFETY RECALL BEGAN ON DECEMBER 6, 2010. OWNERS MAY CONTACT MEDTEC TOLL-FREE AT 1-866-263-3832.

← home