1993 Jeep Grand Wagoneer

ON CERTAIN SPORT UTILITY VEHICLES, IF A DRIVER HAS NOT PLACED THE SHIFTER LEVER FULLY INTO THE "PARK" POSITION AND LEAVES THE VEHICLE RUNNING, THE VEHICLE MAY UNEXPECTEDLY MOVE REARWARD AFTER SEEMING TO BE STABLE.

RiskINADVERTENT MOVEMENT OF THE VEHICLE COULD RESULT IN A CRASH.

FixDEALERS WILL INSTALL A SECONDARY DETENT SYSTEM TO THE FLOOR SHIFTER ASSEMBLY. DAIMLERCHRYSLER SENT INTERIM NOTICES TO OWNERS CONCERNING THIS PROBLEM ON MARCH 22, 2002. OWNER NOTIFICATION BEGAN SEPTEMBER 23, 2002. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT DAIMLERCHRYSLER AT 1-800-853-1403.

VEHICLE DESCRIPTION: PASSENGER AND MULTI-PURPOSE VEHICLES ORIGINALLY SOLD OR CURRENTLY REGISTERED IN THE STATES OF CONNECTICUT, ILLINOIS, INDIANA, MAINE, MARYLAND, MASSACHUSETTS, MICHIGAN, NEW HAMPSHIRE, NEW JERSEY, NEW YORK, OHIO, PENNSYLVANIA, RHODE ISLAND, VERMONT, OR WISCONSIN, AND THE DISTRICT OF COLUMBIA. THE FRONT DISC BRAKE ROTORS CAN EXPERIENCE SEVERE CORROSION IF OPERATED FOR AN EXTENSIVE PERIOD IN THE "SALT BELT." IF THE ROTORS ARE NOT REPLACED, THE CORROSION CAN EVENTUALLY COMPROMISE THE STRUCTURAL INTEGRITY OF THE STAMPED STEEL CENTER HUB SECTION OF THE ROTOR.

RiskTHE REDUCED STRENGTH CAN ALLOW THE CAST IRON WEAR SURFACE TO SEPARATE FROM THE HUB, REDUCING THE BRAKE EFFECTIVENESS OF THE VEHICLE.

FixDEALERS WILL REPLACE THESE ROTORS WITH ROTORS THAT ARE COATED WITH A CORROSION PROTECTION.

THIS IS NOT A SAFETY RECALL IN ACCORDANCE WITH FEDERAL REGULATION 573. HOWEVER, IT IS DEEMED A SAFETY IMPROVEMENT CAMPAIGN BY THE AGENCY. THE CENTER REAR SEAT BELT BUCKLE MAY NOT BE ACCESSIBLE WHEN THE RIGHT (PASSENGER) SIDE OF THE REAR SEAT BACK IS FOLDED DOWN IN THE CARGO STOWAGE POSITION.

RiskIN THE EVENT OF A COLLISION, THE OCCUPANT OF THE CENTER REAR SEAT MAY NOT BE PROPERLY RESTRAINED AND PERSONAL INJURY COULD OCCUR.

FixDEALERS WILL REPLACE THE SEAT BELT BUCKLE ASSEMBLY.

THE MOLDED PLASTIC PIN WHICH CONNECTS THE UPPER STEERING COLUMN SHAFT AND THE LOWER COLUMN SHAFT MAY HAVE BEEN SHEARED PRIOR TO INSTALLATION OF THE STEERING COLUMN ASSEMBLY INTO THE VEHICLE. IF THIS OCCURRED, THE UPPER STEERING SHAFT WILL SEPARATE FROM THE LOWER STEERING SHAFT.

RiskIF THE UPPER AND LOWER STEERING SHAFTS SEPARATE, COMPLETELOSS OF STEERING CONTROL WILL OCCUR, WHICH COULD RESULT IN AN ACCIDENT.

FixA RESTRAINING SLEEVE WILL BE ADDED TO THE INTERMEDIATE SHAFT TO LIMIT THE AMOUNT OF STEERING SHAFT MOVEMENT AVAILABLE.

GREASE APPLIED TO THE LIFTGATE LATCH RUBBER BUMPERS TO EASE COMPONENT ASSEMBLY CAUSED THE BUMPER TO SWELL, INTERFERING WITH THE MOVEMENT OF THE LIFTGATE LATCH PAWL. THIS PREVENTS THE LIFTGATE LATCHING WHEN CLOSED AND DIFFICULT TO OPEN WHEN LATCHED.

RiskAN UNLATCHED LIFTGATE CAN OPEN WHILE THE VEHICLE IS INMOTION, AND COULD RESULT IN AN OCCUPANT FALLING OUT.

FixREPLACE THE LIFTGATE ASSEMBLY ON AFFECTED VEHICLES.

THE ECCENTRIC CAM ADJUSTER BOLTS IN BOTH FRONT LOWER SUSPENSION ARM-TO-FRONT AXLE BRACKET ATTACHMENTS MAY FAIL DUE TO ASSEMBLY MISALIGNMENT.

RiskCAM BOLT FAILURES CAUSE THE VEHICLE TO PULL TO ONESIDE WHEN THE BRAKES ARE APPLIED, RESULTING IN A POSSIBLE LOSS OF VEHICLECONTROL AND AN ACCIDENT.

FixREPLACE THE FRONT SUSPENSION CAM BOLTS, CAM WASHERS, AND NUTS WITH COMPONENTS OF A DIFFERENT DESIGN.

THE RETAINER CLIP WHICH SECURES THE MASTER CYLINDER INPUT ROD TO THE BRAKE PEDAL WAS NOT INSTALLED PROPERLY, AND COULD WORK LOOSE.

RiskDISENGAGEMENT OF THE RETAINER CLIP WILL ALLOW FREE PLAYIN THE ATTACHMENT AND CAN ALLOW THE INPUT ROD TO SEPARATE FROM THE BRAKE PEDALCAUSING COMPLETE LOSS OF BRAKE APPLICATION WHICH COULD RESULT IN AN ACCIDENT.

FixIMPROPERLY INSTALLED RETAINER CLIPS WILL BE REMOVED AND NEW RETAINER CLIPS WILL BE PROPERLY INSTALLED.