Year · Make · Model

1997 International Harvester 8100

What the National Highway Traffic Safety Administration knows about this vehicle: every recall, every consumer complaint, every defect investigation, every NCAP crash test. Sourced directly from NHTSA data feeds.

Open recalls

NHTSA complaints

Defect investigations

Service bulletins

Recalls

3 campaigns

01V023000·SERVICE BRAKES, AIR:SLACK ADJUSTERS2001-02-01

VEHICLE DESCRIPTION: HEAVY DUTY TRUCKS EQUIPPED WITH AIR BRAKE HALDEX AUTOMATIC SLACK ADJUSTERS, LONG STROKE BRAKE CHAMBERS, AND DANA BRAKES. THE AUTOMATIC SLACK ADJUSTER ANCHOR BRACKETS CAN FAIL DUE TO FATIGUE FRACTURE AND COMPLETELY SEPARATE, CAUSING THE SLACK ADJUSTERS TO FUNCTION AS MANUAL SLACK ADJUSTERS.

RiskIF THE SUPPORT BRACKET FOR AN AUTOMATIC SLACK ADJUSTER FAILS, THE BRAKES AT THAT WHEEL END WILL NOT AUTOMATICALLY ADJUST. AS THE BRAKE LININGS WEAR, THE VEHICLE WILL HAVE REDUCED BRAKING CAPACITY, INCREASING THE RISK OF A CRASH.

FixDEALERS WILL INSTALL A NEW BRACKET ON EACH SUSPECT SLACK ADJUSTER. OWNER NOTIFICATION BEGAN FEBRUARY 22, 2001. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT INTERNATIONAL AT 1-800-448-7825.

96V240000·SUSPENSION:REAR1996-11-27

VEHICLE DESCRIPTION: SCHOOL BUSES AND HEAVY DUTY TRUCKS EQUIPPED WITH REAR AXLE ASSEMBLIES PRODUCED BY DANA SPICER. CERTAIN REAR AXLE ASSEMBLIES WERE IMPROPERLY HEAT TREATED WHICH COULD ALLOW PINION BREAKAGE AT THE PINION THREADS.

RiskCRACKS CAN INITIATE AND RESULT IN SEPARATION OF THE THREADED END OF THE PINION RESULTING IN SEPARATION OF THE YOKE AND DRIVE LINE FROM THE REAR AXLE INCREASING THE RISK OF A VEHICLE ACCIDENT.

FixDEALERS WILL REPLACE THE REAR AXLE CARRIER/PINION ASSEMBLY.

96V233002·SUSPENSION:REAR1996-11-22

THE DRIVE AXLE HOUSINGS CONSIST OF A PLATE STEEL CENTER SECTION AND TWO FORGED SPINDLES, ONE OF WHICH IS WELDED TO EACH END OF THE CENTER SECTION. EACH SPINDLE CONTAINS A KEYWAY SLOT IN WHICH THE LOCKING TAB FOR THE WHEEL BEARING NUT LOCKING MECHANISM IS INSERTED. THE LENGTH OF THE KEYWAY SLOT MAY NOT BE LONG ENOUGH TO ACCOMMODATE THE TAB CAUSING THE TAB TO BE DEFORMED OR DAMAGED DURING INSTALLATION.

RiskTHIS LOCKING TAB PREVENTS THE WHEEL BEARING NUT FROM LOOSENING DURING VEHICLE OPERATION. IF THIS TAB IS DEFORMED, THE NUT CAN LOOSEN ALLOWING THE WHEEL TO SEPARATE FROM THE AXLE INCREASING THE RISK OF A VEHICLE ACCIDENT.

FixDEALERS WILL REPLACE THE DRIVE AXLE HOUSING NUTS WITH A CONVENTIONAL WHEEL NUT HARDWARE SYSTEM.

← home