Year · Make · Model

1992 Home AND Park Roadtrek

What the National Highway Traffic Safety Administration knows about this vehicle: every recall, every consumer complaint, every defect investigation, every NCAP crash test. Sourced directly from NHTSA data feeds.

Open recalls

NHTSA complaints

Defect investigations

Service bulletins

Recalls

2 campaigns

93V026000·EQUIPMENT:ELECTRICAL1993-03-02

THE GENERATOR EXHAUST PIPE, LOCATED AT THE REAR ROADSIDE OF THE VEHICLE, CAN EMIT HOT EXHAUST GASES FROM A DAMAGED, WORN, DEFECTIVE, OR IMPROPERLY INSTALLED EXHAUST PIPE, MELTING THE ADJACENT POLYETHYLENE STORAGE TRUNK.

RiskTHE DAMAGED STORAGE TRUNK ALLOWS GENERATOR AND/OR VEHICLEEXHAUST GASES TO ENTER THE VEHICLE, RESULTING IN A HAZARD TO VEHICLE OCCUPANTS.

FixREPLACE ANY DEFECTIVE GENERATOR EXHAUST PIPES, REPAIR HOLES IN THE POLYETHYLENE STORAGE TRUNK, AND INSTALL A HEAT SHIELD BETWEEN THE GENERATOR EXHAUST PIPE AND THE STORAGE TRUNK.

92V157000·SEATS1992-11-02

1) THE SEAT SYSTEM SLIDE TRACKS DO NOT ALLOW THE SEATS TO SLIDE, AND THERE IS AN INCORRECT ANGLE OF THE UPPER TORSO SAFETY BELT CAUSED BY NON-CHRYSLER HARDWARE AT THE SHOULDER SAFETY BELT ANCHORAGES.

RiskTHE VEHICLES DO NOT MEET THE REQUIREMENTS OF FMVSS 207,"SEATING SYSTEMS" AND FMVSS 210 "SAFETY BELT ASSEMBLY ANCHORAGES". OCCUPANTS OFTHE AFFECTED SEATS WOULD NOT BE SUFFICIENTLY PROTECTED IN THE EVENT OF A SUDDENSTOP OR ACCIDENT.

FixREPLACE THE DEFECTIVE SEAT SLIDES WITH A STRONGER DOUBLE LOCKING SLIDE TRACK; REPLACE THE LONG SLIDE TRACKS WITH SHORTER SLIDE TRACKS, AND REPLACE THE NON-CHRYSLER SAFETY BELT ANCHORAGES WITH CONFORMING CHRYLSER HARDWARE.

← home