Year · Make · Model

1994 Freightliner FLA

What the National Highway Traffic Safety Administration knows about this vehicle: every recall, every consumer complaint, every defect investigation, every NCAP crash test. Sourced directly from NHTSA data feeds.

Open recalls

NHTSA complaints

Defect investigations

Service bulletins

Recalls

3 campaigns

97V114001·EXTERIOR LIGHTING:TURN SIGNAL:SWITCH1997-08-04

VEHICLE DESCRIPTION: HEAVY DUTY TRUCK. THE SHOULDER BOLT WHICH HOLDS THE GROTE TURN SIGNAL SWITCH CASE AND COMPONENTS TOGETHER CAN LOOSEN RESULTING IN THE TURN SIGNAL MALFUNCTIONING.

RiskIF THE TURN SIGNAL FUNCTION IS LOST, FOLLOWING MOTORISTS WOULD NOT BE AWARE OF THE TURNING VEHICLE, INCREASING THE RISK OF A VEHICLE CRASH.

FixDEALERS WILL INSPECT THESE VEHICLES AND TIGHTEN ANY LOOSE BOLTS AND IN THE TURN SIGNAL SWITCH WITHIN 2 YEARS FROM THE DATE OF THE RECALL NOTIFICATION LETTER. THE SHOULDER BOLT WILL BE REMOVED, CLEANED, AND REINSTALLED WITH LOCTITE. OWNERS CAN ALSO REQUEST LOCTITE AND REPAIR INSTRUCTIONS SO THEY CAN FIX THE VEHICLES THEMSELVES.

96V232000·ENGINE AND ENGINE COOLING:COOLING SYSTEM:FAN1996-11-13

VEHICLE DESCRIPTION: HEAVY DUTY TRUCKS EQUIPPED WITH HORTON FAN DRIVES. THE FAN DRIVE CONTROL SYSTEM WAS RECONFIGURED WHICH RESULTED IN A SIGNIFICANT INCREASE IN THE DEMAND FOR FAN ACTIVATION AND ASSOCIATED STRESS TO ELECTRICAL AND MECHANICAL COMPONENTS. VARIOUS COMPONENT FAILURE MODELS, COMBINED WITH CHARACTERISTICS OF THE FAN CLUTCH AND ITS BEARINGS, CAN CAUSE FAN CLUTCH BEARINGS TO FAIL PREMATURELY AND RESULT IN A LOCKED FAN.

RiskIF THE FAN IS LOCKED, THE THE SYSTEM CALLS FOR THE FAN TO BE ON, THE FAN CLUTCH WILL SLIP, GENERATE HEAT, AND UNLESS RELEASED, WILL RESULT IN A FIRE.

FixDEALERS WILL REPLACE THE FAN CLUTCH DRIVE DISC WITH ONE THAT INCORPORATES A THERMALLY ACTIVATED PRESSURE RELIEF.

95E003005·SERVICE BRAKES, AIR:SUPPLY:HOSES, LINES/PIPING, AND FITTINGS1995-04-03

AIR SYSTEM BLOCKAGE IN THE AIR DRYER OCCURS DEGRADING THE MOISTURE REMOVING CAPABILITIES OF THE DRYER WHEN THE VEHICLE IS OPERATED IN A COLD ENVIRONMENT AND MOISTURE ACCUMULATES AND FREEZES IN THE AIR DRYER OR IN THE LINE BETWEEN THE DRYER AND THE AIR SYSTEM RESERVOIR. THE AIR DRYER CAN BECOME OVER PRESSURIZED CAUSING THE AIR DRYER CARTRIDGE TO SEPARATE FROM THE MOUNTING BASE.

RiskIF THE AIR DRYER SEPARATES FROM THE BASE, THE CARTRIDGECAN SEPARATE SUFFICIENTLY ENOUGH TO CAUSE PERSONAL INJURY OR PROPERTY DAMAGE.

FixDEALERS WILL EQUIP AIR SYSTEMS WITH A PRESSURE RELIEF VALVE TO BE LOCATED BETWEEN THE COMPRESSOR AND THE AIR DRYER. THIS PRESSURE RELIEF VALVE IS INTENDED TO VENT IF EXCESSIVE PRESSURE DEVELOPS IN THE AIR DRYER.

← home