1984 Ford Ranger

CERTAIN FEDERAL-MOGUL AFTERMARKET FUEL PUMPS SOLD UNDER THE BRAND NAMES OF CARTER, ACCUFLOW, NAPA, TRUFLOW, PARTS DEPO, AND PARTS MASTER, SHIPPED BETWEEN AUGUST 2006 AND JULY 2007 FOR USE ON THE VEHICLES LISTED ABOVE. THE FUEL PUMP DIAPHRAGM IN CERTAIN PRODUCTION RUNS MAY HAVE BEEN IMPROPERLY INSTALLED OR INADEQUATELY TESTED WHICH MAY CAUSE THE FUEL PUMP TO LEAK.

RiskA LEAKING FUEL PUMP COULD CREATE A VEHICLE FIRE HAZARD.

FixFEDERAL-MOGUL WILL NOTIFY OWNERS AND REPLACE THE DEFECTIVE FUEL PUMPS FREE OF CHARGE. THE RECALL BEGAN ON OCTOBER 15, 2007. OWNERS CAN CONTACT FEDERAL-MOGUL AT 248-354-7700.

EQUIPMENT DESCRIPTION: AFTERMARKET BRAKE ROTORS FOR USE ON CERTAIN FORD AND MAZDA TRUCKS. CRACKED CASTINGS CAUSED CRACKS TO APPEAR ON THE OUTER DIAMETER OF THE ROTOR HAT OR AROUND THE STUD HOLE.

RiskLOSS OF BRAKING CAN RESULT.

FixAIMCO WILL REIMBURSE CONSUMERS/INSTALLERS FOR THE COST OF REPLACEMENT ROTORS AND INSTALLATION. CONSUMERS ARE REQUESTED TO RETURN TO THE LOCATION WHERE THE ROTORS WERE ORIGINALLY PURCHASED/INSTALLED FOR REPLACEMENT.

SECONDARY HOOD LATCH COMPONENTS MAY HAVE BEEN IMPROPERLY POSITIONED DURING ASSEMBLY. IF THE HOOD IS NOT CLOSED TIGHTLY, OR IS INADVERTENTLY RELEASED, THE SECONDARY LATCH MAY NOT WORK AND THE HOOD MAY FLY UP WITHOUT PRIOR WARNING.

FixTHE HOOD ASSEMBLY WILL BE INSPECTED AND THE HOOD AND LATCH COMPONENTS WILL BE ADJUSTED, IF NECESSARY, WITHOUT CHARGE TO THE OWNER.

WEIGHT RATING INFORMATION IS INCORRECT ON VEHICLE MANUAL LABELS AND RATING DECALS.

FixDEALERS WILL BE PROVIDED WITH THE REVISED VEHICLE INFORMATION. IF VEHICLE WEIGHT IS FOUND TO BE GREATER THAN THAT SPECIFIED ON WEIGHT RATING, THE AFFECTED VEHICLE"S REAR AXLE MAY BE REPURCHASED FROM FORD. A PRICE ADJUSTMENT WILL ALSO BE MADE IF APPROPRIATE.

IF TRUCK IS STRUCK FROM THE SIDE, THE CAP ON THE FUEL TANK COULD BECOME UNSEALED, ALLOWING UNSAFE LEAKAGE OF FUEL. THIS IS A FAILURE TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD 301, "FUEL SYSTEM INTEGRITY". LEAKAGE CAN BE CAUSED BY AN ORANGE-COLORED PLASTIC DIESEL FUEL INFORMATION RING WHICH IS FOUND AROUND THE FUEL TANK NECK, OR BY THE TETHER.

FixUPON INSPECTION, FUEL CAP TETHERS WILL BE REPLACED OR DIESEL FUEL INFORMATION RINGS WILL BE REMOVED.

COMPONENTS IN THE LOCKING HUBS WERE IMPROPERLY HEAT-TREATED AND MAY CRACK OR FRACTURE UPON ENGAGEMENT OF THE FRONT DRIVE AXLES. THE BROKEN COMPONENT ON THE LEFT FRONT WHEEL MAY BECOME JAMMED AGAINST THE NUT.

FixCAM ASSEMBLIES IN FRONT WHEEL AUTOMATIC LOCKING HUBS WILL BE REPLACED.

THE BOLTS THAT ATTACH THE D-SHAPED RING FOR THE SHOULDER BELT ARE INADEQUATELY SUPPORTED BY THE MATERIAL IN WHICH THEY ARE MOUNTED. THE ATTACHMENT DOES NOT COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 210, "SEAT BELT ASSEMBLY ANCHORAGES".

FixDEALERS WILL INSTALL NEW ATTACHING HARDWARE TO IMPROVE THE STRENGTH OF THE MOUNTING.

VEHICLES MAY HAVE FUEL OR VAPOR LINE DAMAGE CAUSED WHEN AN INCORRECT PROCEDURE WAS USED IN TIGHTENING BOLTS ON ADJACENT COMPONENTS DURING ASSEMBLY. THE FUEL TANK MAY BECOME DAMAGED DUE TO A LOOSE CROSS MEMBER THAT SUPPORTS IT.

FixVEHICLES WILL BE INSPECTED AND, WHEN NECESSARY, FUEL AND VAPOR LINES WILL BE REPLACED AND THE CROSS MEMBER WILL BE TIGHTENED.

STALLING