Year · Make · Model
What the National Highway Traffic Safety Administration knows about this vehicle: every recall, every consumer complaint, every defect investigation, every NCAP crash test. Sourced directly from NHTSA data feeds.
THE REINFORCEMENT FOR THE IN-BOX SPARE TIRE CARRIER MAY HAVE BEEN ATTACHED USING INCORRECT HEX HEAD BOLTS. IF THE CARRIER AND REINFORCEMENT ATTACHING BOLTS ARE INCORRECT, THE POTENTIAL EXISTS FOR THE TIRE SIDEWALL TO BE DAMAGED OR WEAKENED BY EXTENDED CONTACT WITH THE SHARP EDGES OF THE BOLT HEADS.
FixDEALER WILL REPLACE BOLTS AND ANY DAMAGED SPARE TIRES AT NO COST TO OWNER.
THE INVOLVED VEHICLES WERE MANUFACTURED WITHOUT THE MIDSHIP FUEL TANK PROTECTIVE SHIELDS. AS A RESULT, THEY DO NOT CONFORM TO FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 301, "FUEL SYSTEM INTEGRITY", DUE TO EXCESSIVE FUEL SPILLAGE UPON FRONTAL IMPACT.
FixTHE INVOLVED VEHICLES WILL BE INSPECTED AND, IF NECESSARY, A FUEL TANK SHIELD WILL BE INSTALLED AT NO CHARGE TO OWNER.
THE INVOLVED VEHICLES DO NOT HAVE A PROTECTIVE FUEL TANK SHIELD. AS A RESULT THE 137 INCH AND 161 INCH WHEELBASE CHASSIS CABS FAIL TO CONFORM TO FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 301, "FUEL SYSTEM INTEGRITY". IF THE ABOVE VEHICLES UNDERGO FRONTAL IMPACT, THE DRIVE SHAFT FRONT UNIVERSAL JOINT MAY COME INTO CONTACT WITH THE FUEL TANK, RESULTING IN FUEL SPILLAGE.
FixTHE INVOLVED VEHICLES WILL BE INSPECTED AND, IF NECESSARY, A MID-SHIP FUEL TANK SHIELD WILL BE INSTALLED AT NO CHARGE TO OWNER.
THE INVOLVED CHASSIS CABS WERE IMPROPERLY EQUIPPED WITH OUTSIDE REARVIEW MIRRORS WITH A REFLECTIVE SURFACE AREA OF TWENTY SQUARE INCHES, WHICH DOES NOT COMPLY WITH FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 111, "REARVIEW MIRRORS". THIS REQUIRES VEHICLES WITH A GVWR OF MORE THAT 10,000 LBS. TO BE EQUIPPED WITH OUTSIDE REARVIEW MIRRORS OF NOT LESS THAN FIFTY SQUARE INCHES OF REFLECTIVE SURFACE AREA.
FixDEALER WILL INSTALL APPROPRIATE OUTSIDE REAR VIEW MIRRORS AT NO CHARGE TO OWNERS.
THE PARKING PAWL ACTUATING ROD IN THE TRANSMISSION MAY HAVE AN INSUFFICIENT OR CRACKED WELD. THIS CAN CAUSE THE PARK CAM END TO SEPARATE FROM THE ROD ITSELF, PREVENTING THE PARKING PAWL FROM ENGAGING THE PARKING GEAR WHEN THE SELECTOR IS PLACED IN THE PARK POSITION.
FixDEALER WILL REPLACE THE DEFECTIVE PARKING PAWL ACTUATING ROD FREE OF CHARGE.
DUAL REAR WHEEL RETENTION