NHTSA recall campaign
08E018000
What was wrong
Defect
BENDIX IS RECALLING 1,457 MV-3 DASH CONTROL VALVES MANUFACTURED FROM JANUARY 3 THROUGH JANUARY 22, 2008. SOME OF THE UNITS WERE SOLD FOR OEM APPLICATIONS ON NEW MOTOR VEHICLES AND SOME WERE SOLD FOR AFTERMARKET REPLACEMENT EQUIPMENT. AN INCORRECT CORE PIN IN THE INJECTION MOLD OF THE MOLDED VALVE BODY WAS USED CAUSING THE VALVE BODY TO BE OVERSIZED IN THE DOUBLE CHECK VALVE SEAT AREA. THIS CONDITION CAN ALLOW THE RUBBER DOUBLE CHECK VALVE TO BECOME LODGED IN THE BODY OPENING UNDER CERTAIN CIRCUMSTANCES.
Risk
IF THE DOUBLE CHECK VALVE BECOMES LODGED, IN THE EVENT OF A PRIMARY RESERVOIR FAILURE, AIR PRESSURE CAN LEAK PAST THE LODGED DOUBLE CHECK VALVE THEREBY DEPLETING THE SECONDARY RESERVOIR, CAUSING A REDUCED ABILITY FOR MODULATING THE EMERGENCY BRAKES.
Manufacturer remedy
BENDIX WILL PROVIDE A REMEDY WITHOUT CHARGE FOR ALL AFFECTED MV-3 VALVES. BENDIX WILL NOTIFY VEHICLE MANUFACTURERS IMMEDIATELY. OWNERS MAY CONTACT BENDIX AT 440-329-9000.
To check whether your specific VIN is covered and to find a participating dealer, look this campaign up on NHTSA.gov →
Affected vehicles
0 entriesNHTSA did not enumerate affected vehicles for this campaign.